FOREWORD
This maintenance manual describes the daily inspection procedure and regular inspection
procedure.
Since the daily and regular inspections to be carried out by machine operators are very important
in maintaining machine accuracy, operators are required to carry out proper inspection and
maintenance in accordance with the details given in this manual.
For machine specifications, inspection, maintenance and installation information, specific to
individual models, refer to the MAINTENANCE INFORMATION manual, DRAWINGS, PARTS
LIST and INSTALLATION MANUAL published separately.
<Assumed machine operation methods>
NC lathes are machine tools intended to be used to cut blank workpieces of a machinable
material, shape and mass, in a shop or plant which is suitable for the cutting operation.
Use of the NC lathe under criteria other than those stated above is considered inappropriate.
Mori Seiki is not responsible for any danger or damage arising from improper operation of the
machine. Some examples of improper machine usage are indicated below.
(1) Adding any part to, or modifying, the machine without consulting Mori Seiki.
(2) Operating the machine outside the machining range.
(3) Improper use of a workpiece holding device or peripheral.
(4) Using the machine with interlocks or machine protection covers removed, or while the
machine is in an unusable state.
(5) Carrying out machine operation, programming, or maintenance and inspection work without
thoroughly understanding the caution information; i.e. without having read the instruction
manuals carefully.
<Protection for machine operators>
Machine operators are responsible to the following.
(1) Carry out machine operation, programming, and maintenance and inspection work in
accordance with the details in the instruction manuals supplied with the machine.
(2) Only operators who have received proper training and have sufficient understanding of the
caution information are allowed to operate or program a machine tool or carry out inspection
and maintenance on it. With regard to safety related measures, operators must receive
training at least once a year.
(3) Develop a thorough understanding of, and strictly observe, the local regulations relating to the
prevention of accidents and environment conservation.
The illustrations in this manual are used as example. Depending on machines, shapes of
systems may differ from the illustrations in this manual.
For details, refer to the DRAWINGS published separately.
NOTE
To Next Page
Loading...
Need help?
General
