Morita Lubrina 2 User Manual

26
7 Usage
Instructions for Use 2019-01-16
7.3.4 Switching Maintenance Mode
█
Mode 1/Mode2 Switching Procedures
1. Turn the Power Switch on and then open the front door, so that switching operation will not cause the Lubrina
2 to malfunction.
The initial settings are Mode 1 for Lines 1 & 2, and Mode 2 for Lines 3 & 4. Check the handpiece type and select
the most appropriate lubrication mode for each handpiece.
p. 9 “5.2.1 Recommended Mode”
2. Hold down the desired Line Selection Switch and press the Start/Stop Switch for about two seconds until you
hear a single sustained beep.
The Line Selection Lamp and currently set Lubrication Mode Selection Lamp will blink.
3. Press the desired Lubrication Mode Selection Switch.
BEEP!
Example: Change lubrication mode for Line 1 from Mode 1 to Mode 2.
4. Hold down the Start/Stop Switch for about two seconds until you hear two short beeps.
The lamp will change from blinking to steady illumination which completes the setting process.
* The illustration above shows that Line 1 is set to Mode 2.
5. Turn the power o󰀨.
Hold Down

Morita Lubrina 2 Specifications

General

Brand	Morita
Model	Lubrina 2
Category	Dental equipment
Language	English