Morpheus Gargoyle - Page 17

Morpheus Technologies Owner’s Manual
http://www.BaseRigs.com/
Page 17 Morpheus Technologies
Figure 5
Figure 5: Clear the top flap from under the container and place it over the canopy. Bring
the left side flap over and feed the pull-up cord through the top closing loop located on
the top flap. Feed the pull-up cord through the top left grommet and then through the
top right grommet. Be certain that the bridle exits between the top flap and the right
flap.
Figure 6
Figure 6: Place the pin that is closest to the canopy through the loop. Clear the bottom
flap from under the container and bring it up over the canopy. Feed the pull-up cord
through the bottom closing loop located on the bottom flap, then through the bottom
left grommet and finally through the bottom right grommet. Ensuring that the bridle is not
twisted, place the remaining pin (pin that is closest to the pilot chute) through the closing
loop.
It is very important that the closing loops on the Gargoyle Twin do not exceed
3
/
4
” in
length. A small drop of Super Glue placed on the closing loop knot can help reduce
slipping over time.