Morpheus Technologies Owner’s Manual
http://www.BaseRigs.com/
Page 21 Morpheus Technologies
The is a two pin BASE specific container developed in cooperation with Robert
Pečnik (wingsuit pilot and owner of Phoenix-Fly) in response to the growing popularity of
high performance wingsuit flying and tracking. The Wingsuit X-treme’s low profile design
helps improve airflow over the flyers shoulders and back increasing lift and reducing
drag. The Wingsuit X-treme uses a specially shaped pack tray with low line side walls to
distribute the packjob into a more aerodynamic shape. The top closing loop is anchored
using a floor plate (similar to that used in a reserve tray) this allows for packjob to be
compressed more in the yoke area. The Wingsuit X-treme can also be packed using the
standard top flap closing loop method (recommended on non-terminal jumps).
We found that the WSX although a great container for some, was limited to folks that are
extremely neat packers and not everyone out there can say this. Not to mention it only
accommodates canopies up to a 245.
The HELIUM is designed with every size and type of jumper in mind. It incorporates many
features of the Gargoyle twin, such as the “no tension” pin protector flap. This flap is
designed to open cleanly and quickly at low airspeeds, yet has been thoroughly tested
at terminal and withstands the performance of radical freefly manoeuvres
It’s streamline design and curved yoke contours to the user’s body shape and length,
allowing for maximum comfort and flexibility. The backpad offers a longer wider platform
than the standard Gargoyle. Therefore, it is easier to distribute the pack volume so as to
offer a flatter, more aerodynamic pack job. It comes standard with a complete bridle
protection pocket and features a continuous harness system made of type 7 and type 8
webbing. This assures maximum strength at crucial junctures. The HE comes standard with
Streamline Stealth riser covers and floorplate for the ultimate in aerodynamic packing.
The HE comes standard with “Dynamic Corners”. This design allows the tray to open fully,
leaving no edges for the canopy or tail pocket to snag during high-speed horizontal
deployments.
Packing the HE or WS X-treme
Before placing the canopy into the container, read this manual through from cover to
cover. If there is any element that you do not understand please don’t hesitate
contacting us or contact a qualified rigger to assist you in assembly and packing.
To Next Page
Loading...