Morpheus Gargoyle - Page 22

Morpheus Technologies Owner’s Manual
http://www.BaseRigs.com/
Page 22 Morpheus Technologies
Figure 1
Packing the HE or WSX is exactly the same as for the Gargoyle Twin up until after you
have made the first canopy fold in the container (see figure 1 – 3 of Section 3: Packing
the Gargoyle Twin) as above in Figure 1.
Figure 2a and 2b:
Figure 2a 2b: At this point you must split the pack job to allow space for the top closing
loop to pass through. Use the mid rib of the center cell to guide you were to split the pack
job.
Note: The top closing loop passes through the grommet of the floor plate, held in place
by the standard knot and washer. The closing loop needs to be approximately 2” – 3” in
length depending on the canopy size. The closing loop must obviously be shortened if
you intend to use the standard top flap closing method.