Multistage cooking
The oven can be programmed to carry out up to two
consecutive functions. For example, if you wish to first defrost
food for 5 minutes and then cook at 80% power for 7 minutes.
1. Place the food to be defrosted in a suitable microwave safe
container for all the cooking methods to be used. Open the
door and position the container in the centre of the glass
turntable. Securely close the microwave door.
2. Press the DEFROST button twice (d-2 will appear in the
display) and turn the FUNCTION knob to select 5:00
minutes.
4. Press the START/+30SEC/CONFIRM button to save the
setting and enter the cooking time (e.g. 7minutes) by again
turning the FUNCTION knob.
5. Press the START/+30SEC/CONFIRM button again, the
microwave will start to defrost immediately and then work
through the cooking sequence.
6. The display will show the cooking time remaining during
each cooking stage and the oven will bleep one time and 5
times at the end of the 1st stage and the 2nd cooking stage
respectively.
7. Cooking can be interrupted to stir contents or check cooking
progress and proceed as described in steps 8 -10 in the
microwave cooking section (page14).
Notes:
Auto cook and quick start cannot be programmed into
multistage cooking.
Defrost function (time or weight) can only be programmed
at the start of this function.
•
•
3. Press the Microwave / Grill /Combination / Convection
button and turn the FUNCTION knob to select the power
level (e.g. P80).
To Next Page
Loading...
