6
DO NOT ADD HOT LIQUID TO THE JUG.
A
LLOW TO COOL FIRST.
• T
he Measuring Cap
(
1)
c
an be used to measure
s
mall quantities of liquid.
1
P
our the liquid through the Pouring Hole
(
10)
i
n
t
he Lid.
2
Place the Measuring Cap (3) back in the Lid,
twisting to lock/unlock. Then proceed with your
blending.
• Follow the procedure in the ‘Using your Accents
Table Blender’ section, replacing food with the ice
cubes to be crushed.
• Plug in the Blender and turn the Control Dial (7) to
pulse position (P) and hold for several seconds
• Note: The maximum capacity for ice crushing at
any one time is 500ml.
Use your Blender for soups, sauces, drinks,
pates, mayonnaise, dressing etc.
• Do not put dry ingredients into the Blender before
switching on. If necessary cut them into pieces,
remove the Measuring Cap, then with the Blender
running drop the pieces through the Pouring Hole
one by one.
• Never run the Blender with dry ingredients for
longer than 15 seconds.
• Allow to cool for 5 minutes.
• When making mayonnaise, put all the ingredients
except oil, into the blender. Then with the machine
running pour the oil slowly into the Blender
through the Pouring Hole
(10).
• Thick mixture, eg. pates and dips, may require
scraping out with a spatula. Ensure the
appliance is switched off first. If the mixture is
difficult to process add more liquid.
• When blending, pour the liquids in first and then
add the solid food. Begin blending at the lower
speed and increase when needed.
IMPORTANT: To ensure the long life of your
blender, never run it for longer than 60 seconds
and allow to cool for 5 minutes. Switch off as
s
oon as you have reached the desired
c
onsistency.
• T
he machine will not work if the Glass Jug
(
3)
i
s
fitted incorrectly.
• D
on’t use the Glass Jug as a storage container.
Keep it empty when not in use.
• N
ever blend more than 1 litre (13⁄4 pints) - less for
frothy liquids, such as milk shakes.
• D
o not overfill the blender. This could cause
damage to the motor. The plug fuse will blow if
the blender is overloaded. Replace the fuse and
do not exceed the maximum recommended
volumes. Refer to the ‘Operating chart’ on page 7.
• Before cleaning and maintenance, switch the
appliance off and unplug it.
• After use, fill the Glass Jug (3) with 1L (1
3
⁄4 pints)
of warm water and run for 30 seconds on the
pulse setting and repeat as necessary. Never use
abrasives or cream cleaners.
• Clean the Base Unit (6) with a damp cloth or
kitchen paper roll.
• There is a facility to wrap your power cable
around the base of the product and fit the plug
into the Plug Holder
(11).
• Reassemble the Accents Blender by carefully
placing the Glass Jug on the Base Unit, ensuring
it fits correctly.
• WARNING : Never immerse the Base Unit in
water.
• WARNING: If any liquid is spilt in the top of the
Base Unit, switch off and unplug from the
socket and dry with a cloth.
Crushing Ice
Top Tips
Care And Cleaning
Measuring Cap
IMPORTANT
To Next Page
Loading...
