7
1. Firstly, assemble the Driving Shaft (6) onto the Motor
Base
(7), making sure it is clipped into position
2
. Place the Bowl
(
5)
o
n the Motor Base
(
7)
,
aligning
w
ith the unlock position and turn anti-clockwise
locked into position. The Food Processor will not
work if it is not correctly in place.
3
. Insert the Chopping Blade
(
4)
o
nto the Driving Shaft
(
6)
s
ecurely. Make sure it is pressed into position.
WARNING: Sharp blades.
4. Place the prepared food into the Bowl
(5). The food
m
ust be cut into small chunks.
5. Place the Lid
(3) onto the Bowl (5) and turn it
clockwise until locked into place. Make sure it is
locked in position correctly, otherwise the appliance
will not start.
6. Plug into the wall socket and set the Speed Dial
(8)
to your desired speed.
7. There are four settings: P, 0, 1 and 2. The 1 setting is
the low speed, the 2 setting is the high speed. Turn
the Speed Dial (8) to the P position and hold it to
pulse. Release it to return to the 0 positon. The
pulse mode allows you to create a burst of power
for quick, powerful blending.
8. Turn the Speed Dial
(8) to the 0 position and unplug
the appliance after chopping. Open the Lid
(3) and
remove the Chopping Blade
(4). To remove the Bowl
(5), turn anti-clockwise to release from the Motor
Base
(7) Empty the chopped food.
CAUTION: The Blades are extremely sharp,
handle with care.
Below are foods that are not suitable for chopping.
Hard substances: Cheese, dried fruits and certain
vegetables (Carrots and Celery)
Soft Substances: Certain vegetables
(Onions and Spinach)
Raw and cooked meat: (boned and sliced)
CAUTION: The total operating time should not be
more than 90 seconds.
1. Unplug from the power socket before cleaning
2. Empty the Bowl
(5), dismantle all detachable parts
a
nd wash with warm, soapy water and dry
t
horoughly.
CAUTION: Care must be taken when handling
the blade as it is very sharp.
3. Wipe the Motor Base
(7) with a damp cloth and dry
thoroughly. Never immerse it in water. Ensure the
interlock area is free from food.
QUICK CLEANING
Pour some water (200ml) and a drop of washing up
liquid into the Bowl
(5), turn and hold the Speed Dial
(8) to the P position for a few seconds for quick
cleaning. (Chopping Blade to be fitted to agitate the
water).
No parts are dishwasher safe.
Chopping Cleaning After Chopping
To Next Page
Loading...
