Place the Coffee Filter (18/19/20) into the Filter
Holder (21) without coffee in the Filter. Place the
Filter Holder into the Brewing Head (10) and turn
until at a right angle to the Main Unit to lock into
position securely.
Fill the Water Tank
(8)
up to the MAX line.
Assemble the Espresso Coffee Machine as above,
ensuring the Removable Drip Tray
(15)
is in place.
When the Two Cup and One Cup Buttons (2/3)
illuminate solidly, place your cup(s) on the Drip
Tray Grid (11). Press either the One or Two Cup
Button to dispense set amount, approximately
50ml for one cup and 100ml for two.
Empty the water from your Espresso cup.
Next, follow steps 2 onwards under ‘Using Your
Coffee Maker’ on the following page, using your
preheated Espresso cup.
Remove the warmed Filter Holder
(21), ready for
use (see steps 2 and 3 under ‘Using Your Coffee
Maker’ on the following page).
Plug the Espresso Coffee Machine in and press
the On/Standby Button
(4). The button will
illuminate and remain on until the coffee machine
is switched off again. The Two Cup and One Cup
Buttons (2/3) will pulse.
Re-filling the water tank
If the Water Tank (8) runs dry, after re-filling it
may require two or more presses of the Two Cup
and/or One Cup Buttons (2/3) for water to flow
through the system to make an espresso.
To Next Page
Loading...
Need help?
General
