Morphy Richards SPEED STEAMPRO - Before Use and Initial Setup; Using the Steam Generator; Water Tank Filling and Power On

6
Using the Steam Generator
Plug the appliance into a mains outlet. Press the
On/Off power button
(23), it will beep and the
low steam level indicator
(25a) will flash.
2
Remove the detachable water tank (12) by pulling
the water tank handle
(11), and fill with water
through the filling aperture
(1) to the max fill line .
Replace the water tank.
IMPORTANT: Never fill the dirty water chamber
(2) .
IN HARD WATER AREAS, WE RECOMMEND A
MIX OF 50% TAP WATER AND 50% DISTILLED,
DEIONISED OR DEMINERALISED WATER.
Never use battery topping up fluid or water
containing any substances like starch, sugar,
fragrant additives or defrosted water from a
refrigerator.
NOTE: Please see point 2 of ‘Exclusions’ on page 12.
Re-filling during use
If the water level is too low, the unit will not
produce steam. If this happens, refill the
detachable water tank
(12) with water.
1
R
emove any protective cover from the soleplate
(
6)
a
nd the base unit
(
17)
.
U
nwind and straighten the power cord and steam supply cord.
Locate the steam generator horizontally on the iron rest plate of your ironing board (if large enough) or on a
h
eat resistant stand at the same height as your ironing board or below it. Always ensure the steam
g
enerator is on a firm surface when ironing.
WARNING: Do not use the product on a surface which could be damaged by heat or steam such as
a worktop or a polished wood surface.
If in doubt, contact Morphy Richards.
Lo
c
a
t
i
o
n
Be
f
o
re
use
RN332100 MUK Rev1.qxp_IB 01/08/2018 16:11 Page 6