13
Operation
Starting up and temperature regulation
0
1
2
3
4
5
6
7
Changing the light bulb
LED light
Lampshade
Screw
Control Box
Bulb fixed block
Warning! When changing the side at which the door opens, the appliance must not
be connected to the mains. Remove plug from the mains beforehand.
Setting 0 means:
Off.
Clockwise rotate the knob to turn on the
appliance
Setting 1 means:
Highest temperature, warmest setting.
Setting 7 (end-stop) means:
Lowest temperature, coldest setting.
Important!
Normally we advise you to select
setting of 2 or 3 or 4, if you want the
temperature higher or colder please
turn the knob to warmer or colder
setting accordingly.
Important!
High ambient temperatures (e.g. on
hot summer days) and a cold setting
(position 6 to 7) may cause the
compressor to run continuously or
even non-stop!
Reason:
when the ambient temperature is high,
the compressor must run continuously
to maintain the low temperature in the
appliance
Insert the plug of the connection lead
into the plug socket with protective
earth contact. When the refrigerator
compartment door is opened, the
internal lighting is switched on.After
the fridge has been placed in
position,wait for 5 minutes before
electricity is supplied. Don't store
anything until the temperature inside
the fridge becomes low enough.
The temperature selector knob is
located on the top of the
refrigerator compartment.
Warning! If the LED light is
damaged IT SHOULD NOT BE
CHANGED BY THE USER!
Changing the LED light carried out by
inexperienced persons may cause
injury or serious malfunctioning. It
must be replaced by specialized
persons in order to avoid a hazard.
Contact your local Service Center for
help.
To switch off the appliance, set the
temperature regulator to position “0”.
Unplug the mains plug.
Before changing the LED light,
switch off the appliance and unplug
it, or pull the fuse or the circuit
breaker.
LED Light data: 220-240V,max1.5W.
Press the Lampshade, and slide it
To change the LED light, undo the
screw .
Remove the bulb fixed block, change
the defective LED light .
Refit the bulb fixed block, the LED
light cover and the screw.
Put the refrigerator back into
operation.
To Next Page
Loading...
