Need help?Do you have a question about the Morrison Bros. co. 1218C and is the answer not in the manual?
General| Brand | Morrison Bros. co. |
|---|---|
| Model | 1218C |
| Category | Measuring Instruments |
| Language | English |
Details on connecting intrinsically safe sensors to the 1218C console.
Specific instructions for connecting sensor wires to the console.
Detailed instructions for connecting mains power to the console.
Instructions for wiring the dry-contact output switches to devices.
Instructions for routing and connecting the Ethernet cable to the console.
Explains the dual functions of the Silence/Test button.
How to connect the 1218C via a network for web access.
Steps to access the 1218C's web interface.
Defining physical tank characteristics and current fluid level.
Calibrating the sensor to the tank by measuring fluid level.
Defining the percentage of fill level for alarm trip.
Configuring sensor inputs for dry contact devices.
Setting up output parameters like Alarm Sources, Type, and Mode.
How the system logs events and the information recorded.
Configuring the 1218C as a Modbus server (TCP or RTU).
Procedures for saving and restoring system configuration via USB.
General safety warnings related to operation.
Procedure to prepare for and initiate a fill operation.
Overview of configurable alarm types: Level and Sensor Input.
How to access and navigate the Quick Menu using the Silence/Test button.
Saving event log data to USB or via the website interface.
Step-by-step guide to saving the event log to a USB drive.
General safety warnings applicable to maintenance tasks.
Procedure for replacing the coin cell battery every five years.
Detailed steps for safely replacing fuses in the unit.
How to upgrade the unit's firmware via web or console.
Procedures for reverting to previous or factory default firmware versions.
Steps to upgrade firmware using a USB drive via the console.
Options to revert to a previous or factory default firmware version.
Detailed steps to revert to an earlier firmware version.
Detailed steps to restore the unit to factory default firmware.
Resetting all configurations to factory defaults and clearing the event log.
Configuring network parameters like DHCP, IP address, and host name.
Instructions for connecting the remote console via Belden #7933A cable.
Method to upgrade firmware on a secondary console.
Configuring computer's IP address and subnet mask for direct connection.
Wiring connections for Modbus RTU using the remote console connector.
How Modbus TCP connections are made using the Ethernet port.
Configuring Modbus status and interface (RTU/TCP).
Explains using Discrete Inputs and Input Registers for Modbus communication.
Table listing discrete input registers and their values.
Table listing input registers for level, volume, and alarm status.
To Next Page
