morse CSM9NXTB Metal Devil - Laser Sight Guide System and Alignment

MACHINE PREPARATION and OPERATION (Cont.)
LASER SIGHT GUIDE SYSTEM
1 The laser sight system is intended as a guide only
and should not be used for accuracy of the cut.
2 Depress laser power switch (g. 13)
3 Laser Beam follows the angle of the base plate.
4 Align laser beam with your cut line.
5 After completing the cut depress the laser power switch
to disconnect power to laser.
ALIGNMENT TIP FOR LASER SIGHT GUIDE
1 Find a square, at work piece of either steel or plywood
and place the work piece on a table.
2 Push the blade guard up and away from the blade.
Place the saw on the top of the work piece. The side of
the blade should touch the edge of the work piece. (g. 14)
ADJUSTING FOR PARALLEL
Depress laser power switch. If the laser line does not line up
with the edge of work piece (g. 15) then:
a. For small adjustments use an M2 Hex key and loosen or
tighten the screw adjustment (g. 16) to bring the beam
back to parallel.
b. For larger adjustments use a small at head screw driver
to the slot in the front of the light (g. 17) to realign the
beam. Then use the M2 hex key and loosen or tighten
the screw in order to do the nal positioning. (g. 16)
c. The laser light and the 2 sight line markings on the base
plate should now be in the same plane.
6
(g. 13)
(g. 15)
Do not overturn the adjustment
screw on the front of the light.
You could damage threads or the
plastic housing for the laser.
CAUTION
Turning the laser o does not turn
power o to the saw.
READ AND SAVE ALL INSTRUCTIONS FOR FUTURE USE!
LASER RADIATION
Avoid direct eye contact
with light source.
Do not point laser at anyone.
Never look into the laser light.
DANGER
Do not turn on saw
for this adjustment!
Serious injury could result.
(g. 14)
(g. 16) (g. 17)