8
READ AND SAVE ALL INSTRUCTIONS FOR FUTURE USE!
TROUBLESHOOTING
(Cont.)
SYMPTOM POSSIBLE CAUSE CORRECTIVE ACTION
Saw will not start No supply of power Check that saw is plugged in
And that there is power to source.
Brushes are worn or sticking Disconnect power, open brush caps
and ensure brushes move freely in
the holders. Check whether brushes
require replacing.
Switch is faulty Contact Repair Center
Cord Damage Contact Repair Center
Motor Components Open Contact Repair Center
Or short circuited.
Overload Switch is Activated Push switch to reset
Saw produces Dull, damaged blade or Replace the blade
poor cuts incorrect blade for the
application.
Motor is overloaded Reduce the amount of force being used
to push the blade through the cut..
Saw produces an Mechanical obstruction Contact repair center.
unusual sound
Armature has shorted out Contact repair center.
Blade is out of balance Replace blade.
Excessive sparking occurs Brushes are not moving Disconnect power, remove brushes,
Inside motor housing freely Clean or replace.
Armature short circuited, Contact repair center.
open circuitt, or commutator
is dirty
To Next Page
Loading...
