4
ENG
In situations where the stove is to be fitted into a brick or non-combustible recess, we recom-
mend that the stove is installed with at least 10 - 15 cm clearance to the wall, this will allow
heat to circulate around the stove; also the maintenance of the outside stove is easier. When
applied to masonry, a layer of wallpaper is normally classified as a non-combustible surface.
On the floor
National and Local Building Regulations must again be observed when considering the type,
thickness and area of the hearth to be used in the installation. Max Hearth temperature under
safety test was 45°C. One should of course always make certain that the underlying floor sur-
face can bear the weight of the stove.
Distance to furniture and soft furnishings
We recommend that the stove be installed 700 mm from furniture. Serious consideration
should also be given to positioning of any furniture that could be adversely affected by heat.
The clearances to combustible materials in front of the stove should be a minimum of 700
mm. When lit, a wood-burning stove gets hot and therefore adequate protect must be pro-
vided, particularly in situations where there is a safety risk to children or the infirm. A suitable
safety guard around the stove should be considered.
The stoves handle also gets hot when the stove is lit, which is why a safety glove is included
with the stove.
1.5 The chimney
Only if National or Local Regulations permit are you permitted to connect a stove into a chim-
ney that is shared by another appliance. YOU MUST be aware of any applicable Regulations
in this respect.
1412/1452 corner installation 1442 corner installation
Stove type Behind the
stove (A)
To the sides of Above the
the stove (B) stove
To soft
furnishings
Morsø 1412/1452
uninsulated flue
200 mm 600 mm 500 mm 700 mm
Morsø 1412/1452
insulated flue
100 mm 600 mm 500 mm 700 mm
Morsø 1442
uninsulated flue
200 mm 300 mm 500 mm 700 mm
Morsø 1442
insulated flue
100 mm 300 mm 500 mm 700 mm
Minimum clearances to combustible surfaces:
To Next Page
Loading...
