EasyManua.ls Logo

Morso 1442 - Controlling the burning rate; Riddling and ash clearance; Refuelling; Reduced or overnight burning

Morso 1442
16 pages
Print Icon
To Next Page IconTo Next Page
To Next Page IconTo Next Page
To Previous Page IconTo Previous Page
To Previous Page IconTo Previous Page
Loading...
9
ENG
1. A layer of embers will form rapidly if the stove is lit with
2 - 4 fire lighters or 7 - 10 rolled up sheets of newspa-
per, underneath roughly 1 kg of dry kindling.
2. Fully open the top vent so that the secondary air sup-
ply can enter the firebox.
3. After the paper/fire lighters have caught fire, leave the
fire door ajar about 2-3 cm, so that the chimney draws
well.
4. After 5-10 minutes the chimney draft should be establis-
hed, at this point close the fire door. If all the necessary
conditions are met, a nice layer of embers will start to
accumulate after another 15 - 20 minutes.
2.1 Lighting and refuelling intervals
A lot of air is needed when first lighting the stove. When starting with a totally cold stove, it
may be helpful to leave the door ajar (2-3 cm) during the first few minutes; the secondary air
intake should be fully open. You should build and maintain the ash bed to a thickness of ap-
proximately 1 cm.