3
ENG
In situations where the stove is to be fitted into a brick or non-combustible recess, we recom-
mend that the stove is installed with at least 10 - 15 cm clearance to the wall, this will allow
heat to circulate around the stove; also the maintenance of the outside stove is easier.
When applied to masonry, a layer of wallpaper is normally classified as a non-combustible
surface.
1.1 Unpacking the stove
After removing the outer packaging, flatten it and lay onto the floor close to the stove; this
can then act as protective work surface during the assembly process.
Next, remove the legs and bolts from inside the stove. Gently lay the stove onto its back and
unscrew it from the wooden pallet. Using the bolts supplied, now screw the legs into position
on the underside of the base. The stove should now be lifted and moved into the upright po-
sition, avoiding excess load on the back legs.
The stove is heavy and therefore it is strongly recommended that when lifting, iti is undertaken
by two people. Morsø 3610 weighs 199 kg. Morsø 3640 weighs 209 kg.
1.2 Installing the stove
The stove and chimney installations MUST comply to all current National and Local Build-
ing Regulations; your approved Morsø dealer or your local building control officer can advise
regarding this. Ultimately, it is you and your installer who is responsible that the installation
complies.
1.3 Chimney sweep
It may also be wise to consult your local chimney sweep before installing the stove. After your
stove has been installed, it is advisable to have the chimney checked and swept at least once
a year. In any case, if your chimney has not been used for some time, it should be inspected
for cracking, bird nests, etc. before it is put back into use.
1.4 Stove placement/distance requirements
Clearance requirements apply only if the stove is placed near to combustible materials. Per-
mitted clearances to combustible materials are indicated on the data plate on the rear of the
stove.
1.0 Installing your Morsø stove
3610 corner installation 3640 corner installation
Minimum clearances to combustible surfaces:
Stove type Behind the stove (A) To the sides of the stove (B) To soft funushings
Morsø 3610/3640 200 mm 400 mm 1000 mm
uninsulated flue
To Next Page
Loading...
