Morvelli FHD22 - Page 7

7
9
Connecting to another
Wi-Fi network (or if you
changed your Wi-Fi
password)
You need to disconnect the
camera from your account
(or reset using the button
on the back of the camera,
holding it for 5-10 seconds)
and reconnect the camera to
the new Wi-Fi network
10
Don’t receive
notications about
motion in camera eld
of view
1) Motion sensor mode is not
enabled
2) Detection notications are
not congured in Smart Life
account
3) Detection notications
are not congured in your
smartphone
11
Ofine camera 1) There is no internet
2) No Wi-Fi signals
3) Wi-Fi signal is too weak
8
The camera will not
connect to my Wi-Fi
router
1) Perhaps you have a router
(Wi-Fi network) that operates
at 5GHz. Solution: Connect
the camera via Ethernet
cable or use WIFI extender
(increases the range of the
Wi-Fi signal and converts
the frequency from 5Ghz to
2.4GHz)
2)If your router operates at
two frequencies (5Ghz and
2.4GHz), try temporarily to
disable the 5GHz frequency,
connect the camera, and
then turning 5GHz back on