When the walking machine stops running, if there is no operation for more than
10 minutes, it will enter the sleep state, and the electronic watch will automatically
turn off the display. Press any key to wake up the electronic watch, and then
enter the initial standby state again after full display.
VI. Sleep Function Description
E01： Indicates that the communication between the electronic watch and
the electronic control is abnormal.
E02： Indicates that there is an abnormal phenomenon in the measurement
between the lower controller and the motor.
VII. Error Message Prompt Description
E01
Solutions
to
Common
Problems
The communication line of
the electronic watch is not
connected properly, broken,
poor contact
Please reconnect the
communication cable
Electronic watch has no
signal output
Replace the electronic watch,
pending repair
Down control no signal
output
Replace the lower control,
pending maintenance
E02
Solutions
to
Common
Problems
The motor cable is not
connected properly
Check if the motor wire is
connected correctly
Down control has no
voltage output or abnormal
voltage output
Replace the lower control,
pending maintenance
Bad motor Replace the motor
07
To Next Page
Loading...