Maintenance Instructions
In order to better maintain your electric treadmill and prolong the life of the
machine, it is recommended that you turn off the power after 2 hours of
continuous use and let the machine rest for 10 minutes before using it. If the
running belt is too loose, it will slip during running; if it is too tight, it may
reduce the motor performance and increase the wear of the roller and running
belt. When the running belt is tight enough, you can lift both sides of the
running belt about 50-75mm away from the running board by hand.
1. We mentioned above that the running board should be lubricated in time,
but it should not be excessively lubricated. The more lubricant, the better.
Remember: Proper lubrication is an important factor in improving the life of
your treadmill.
2. The way to check whether you need to apply lubricant again, just grab the
running belt and touch your hand to the center of the back of the running
belt as much as possible. If your hand is stained with silicone oil (a little
damp feeling), it means no It needs to be lubricated again, if the running
board is dry and the silicone oil is not sticking to the hand, you need to add
lubricating silicone oil.
3. The steps of coating the running board with lubricating silicone oil:
a. Stop the running belt and fold the machine;
b. Lift the running belt on the back of the treadmill; put the oil can into the
middle of the running belt as much as possible, spray the silicone oil on
the inside of the running belt, and coat both sides of the running belt with
silicone oil. Use the speed of 1km/h to run the treadmill. To spread the
silicone oil evenly, and lightly step on the running belt on the front of the
treadmill from left to right, it will take about a few minutes for the silicone
oil to be completely absorbed by the running belt.
Running Board Lubrication
15
To Next Page
Loading...