EasyManua.ls Logo

MOTO GUZZI CALIFORNIA VINTAGE User Manual

MOTO GUZZI CALIFORNIA VINTAGE
200 pages
To Next Page IconTo Next Page
To Next Page IconTo Next Page
Page #1 background imageLoading...
Page #1 background image
part# MG977374
USE+MAINTENANCE BOOK
VINTAGE

Table of Contents

Question and Answer IconNeed help?

Do you have a question about the MOTO GUZZI CALIFORNIA VINTAGE and is the answer not in the manual?

MOTO GUZZI CALIFORNIA VINTAGE Specifications

General IconGeneral
Displacement1064 cc
Bore x Stroke92 mm x 80 mm
Cooling SystemAir-cooled
Fuel SystemElectronic fuel injection
IgnitionElectronic
Transmission5-speed
Rear BrakesSingle disc
Engine TypeV-Twin, 4-stroke
Front SuspensionTelescopic fork
Rear SuspensionSwingarm with twin shock absorbers
Front BrakesDual discs
Fuel Capacity19 liters
Power74 hp (54 kW) @ 6400 rpm
Torque94 Nm @ 5000 rpm
Seat Height780 mm

Summary

SAFE DRIVE

Basic safety ryles

Requirements for driving, including licence, age, psychophysical ability, insurance, and registration.

Post-Accident Checks and Procedures

Vehicle Inspection After Accident

Check control levers, pipes, cables, braking system, and vital parts for damage after an accident.

Riding Apparel and Safety

Crash Helmet and Protective Clothing

Wear approved, correctly fastened helmet and protective clothing. Ensure visibility and proper fit.

Luggage and Load Management

Luggage Security and Load Limits

General Specifications - Engine

Engine Details

Specifications for the 4-stroke, 90° V-twin engine, including bore, stroke, capacity, and compression ratio.

General Specifications - Drivetrain and Chassis

General Specifications - Brakes and Dimensions

Braking System Details

Specifications for front and rear brakes, including disc size, caliper type, and hydraulic transmission.

Refueling and Lubrication Recommendations

Recommended Fluids and Capacities

Table listing parts to refill, quantities, and recommended products for fuel, oil, and brake fluid.

Vehicle Identification Numbers

Frame and Engine Number Locations

Locates frame number on downtube and engine number on crankcase for identification and legal purposes.

Replacement Parts

Use of Genuine Spare Parts

Always use approved MOTO GUZZI Original Spares. Non-original parts void warranty.

Instruments and Controls - Control Panel

Control Panel Overview

Identifies key switch positions (OFF, ON, LOCK, P) and their functions.

Lighting Controls

Horn, Passing Light, and Turn Signal Controls

Starting and Stopping Controls

Starter Button and Engine Stop Switch

Details the location and operation of the starter button (C) and engine stop switch (B) on the right handlebar.

Engine Stop and Key Operation

Front Brake Lever and Choke Control

Gear Change Pedal Operation

Fuel System and Safety

Fuel Filler Cap Operation and Safety

Instructions for opening the fuel cap and crucial safety warnings regarding fuel flammability and refueling precautions.

Fuel Handling and Safety Precautions

Electrical System - Fuse Box

Fuse Box Location and Identification

Locates the fuse box and explains the 7 fuses, their ratings, and protected circuits.

Fuse Maintenance Warnings

Chassis and Suspension Adjustments

Chassis and Bodywork Features

Riding Your Motorcycle - Pre-Ride Checks

Pre-Ride Checks

Check fuel level, engine oil level, ignition key position, acoustic/visual devices, and warning lights before starting.

Warm Engine Starting Procedure

Riding Your Motorcycle - Stopping and Parking

Stopping the Motorcycle Safely

Instructions for closing throttle, using brakes, disengaging clutch, and engine braking. Advises against abrupt stops.

Parking Procedures and Safety

Running-In Procedure

Running-In Recommendations

Follows rules for running-in: warm engine, avoid exceeding RPM limits, vary speed, gradual braking, and check oil levels.

Running-In Recommendations

Maintenance and Adjustments - Clutch

Adjusting the Clutch Lever

Instructions for adjusting clutch lever free play (3-4 mm) using adjuster screw (A) or cable adjuster (B).

Maintenance and Adjustments - Brakes

Checking Brake Pad Wear

Instructions to check brake pad thickness (wear limit 1.5mm). Replace pads if below limit. Check flexible hoses.

Checking Brake Fluid Level

Instructions for checking brake fluid level in front (A) and rear (B) reservoirs. Top up if low, use recommended fluid, change every 20,000 km or annually.

Brake Fluid Handling and Lubrication Safety

Wheel Removal and Installation

Tyre Maintenance and Specifications

Scheduled Maintenance Program

Maintenance Schedule by Mileage

Table detailing maintenance operations (checks, cleaning, replacements) at various mileage intervals (1500km to 50000km).

Lubrication - Engine

Engine Oil Level Check

Instructions for checking engine oil level every 1000 km using dipstick (A). Top up with recommended oil if low.

Engine Oil Change Procedure

Lubrication - Oil Filters

Oil Filter Cartridge Replacement

Instructions for replacing filter cartridge (A) and cleaning mesh filter (D) at specified intervals. Recommends dealer service.

Lubrication - Gearbox and Rear Drive

Gearbox Oil Level Check

Instructions for checking gearbox oil level every 5000 km using plug (B). Top up with recommended oil if low.

Rear Transmission Box Oil Level Check

Instructions for checking rear transmission oil level every 5000 km using plug (A). Top up with recommended oil if low.

Gearbox Oil Change Procedure

Details gearbox oil change intervals (first 500-1500km, then every 10000km), procedure with warm gearbox, and oil quantity.

Injection and Ignition System

Fuel Circuit Components

Injection and Ignition System - Operating Phases

Spark Plug Checks and System Adjustments Warning

Injection and Ignition System - Adjustments

Maintenance and Lubrication - Filters

Ignition System - Spark Plugs

Spark Plug Installation and Maintenance Warnings

Electrical Equipment

Electrical Equipment - Battery

Electrical Equipment - Lighting

Electrical System - Lighting Adjustment

Electrical System - Lighting Specifications

Electrical System - Wiring Diagram

Electrical System - Fuse Specifications

Fuse Identification and Ratings

Table listing fuses (F1-F7) with their amperage ratings and protected circuits.

Related product manuals