EasyManua.ls Logo

Motocaddy CUBE - Bag Support Adjustment & Parking Brake Use; Adjusting Bag Support Straps; Operating the Parking Brake

Motocaddy CUBE
8 pages
Print Icon
To Next Page IconTo Next Page
To Next Page IconTo Next Page
To Previous Page IconTo Previous Page
To Previous Page IconTo Previous Page
Loading...
Page 7
Adjusting the Bag Supports / Using the Parking Brake
Adjusting the Bag Supports
The bag support straps are manufactured from elasticated material to allow your golf bag to be held
tightly in place.
The strap should be adjusted to be reasonably tight around the golf bag:
1. Unclip the elasticated straps from the housing by pulling outwards in the direction shown (g. 1)
2. Move the bar as required to tighten or loosen the strap tting. Pulling the bar downwards will
tighten, pushing it upwards will loosen (g. 2)
3. Ensure that the straps are clipped back into the housing before use
Using the Parking Brake
To apply or release the foot brake press down on the pedal (g. 3).
The foot brake is designed to be used as a parking brake (like a hand brake of a car or foot brake on
a pram). When applying the brake, please ensure that the trolley has completely stopped moving.
WARNING: Attempting to apply the brake whilst the trolley is still in motion may cause damage
to the trolley and could invalidate the warranty.
Always ensure that the parking brake has been disengaged before attempting to set off again.
Fig 1
Fig 2
Fig 3

Related product manuals