5
Therefore no other devices, relays, boxes or units as part of the wiring harness are necessary. A
complete new and minimised vehicle wiring can be made with minimal time, materials and effort;
compared to conventional solutions, only a fraction of space and cables is needed. State of the art
technology like pulse width modulation afford new possibilities like connecting rear and brake light
together with only one cable. When using m.button, the number of handlebar instruments
connections will be reduced to a single cable by use of our interference-free, proprietary data bus.
The current status of each circuit is shown by an internal LED at the m-unit's topside :
LED off - input not active, output not powered
LED on - input active, output powered – normal condition
short flashing - output shut-down due to short-circuit or overload
Turn Signals
Automatic shut-off can be adjust in setup menu. If this feature is activated a countdown will start
once the signal is flashing. If the adjusted countdown has ended the turn signal stop flashing. The
countdown will stop and set back if the brake is activated. Once the brake is released the
countdown start again with full time length. If a turn signal switch is used and signals has been
automatically shutting down, the switch has to set back to centre prior set the turn signal switch
again to left or right. If two turn signal push button are used is additionally the lane change mode
available. If the button is pressed very shortly the signals will flash only 3 times.
Hazard light
For starting the hazard light hold the push buttons for left and right turn signal for 2 seconds. If a
turn light switch is used, the hazard light function can only be activated if a additional hazard light
switch is activating both turn light inputs at the same time. The hazard light mode will stay active
even if the main (ignition) switch is deactivated.
Light control
In order to save the vehicles battery power the head light is switched off after key lock is switched
on. The head light will be activated automatically after pressing the start button. Further light
control modes can be selected under setup menu no. 8.
If a push button is used for high/low beam control, a short push will toggle between high and low
beam. Holding the button for 2s will switch off the light completely. Pressing the push button again
will switch the low beam light back on. A brief touch of push button is used for headlight flashing.
When using a switch for light control, it's possible to toggle between high and low beam only.
(Please refer to connection scheme.)
The light outputs (Light Hi Out / Light Low Out) can switch 120W each and are designed for a
maximum load of two halogen bulbs with 55W (low beam) and 60W (high beam) respectively.
The parking light has to be activated under setup menu no. 12. The parking light is switched on,
when on turning off the ignition the high beam light is activated. For the parking light feature, there
is no need for an extra illuminant; the feature is realised with the existing illuminant for low beam /
rear light. Parking light activation is signalised by two brief horn sounds. To avoid excessive battery
discharge, please make sure, the parking light is switched on for 2h max.
Kill switch
The running engine can be stopped in three different ways:
a) Double-clicking of engine start button
Pressing the button again after engine stop will crank and start the engine in normal way.
b) Connecting a separate kill switch or push button at the "config" terminal. If a push button is used
the engine is stopped if push button is shortly pressed. To release the kill function hold the button
again for 2 seconds or switch ignition lock off and on again. If a kill switch is used wait for 2
seconds between switching engine off and release the kill switch.
c) When implementing controls with four push-buttons, the engine is killed by pressing the buttons
for light and right turn indicator at the same simultaneously.
To Next Page
Loading...
Need help?
General