This function can prevent other two way radio from disturbing. There are two
customer to select in the programming software.
FREQUENCY: It is not allowed to transmit or make other operation while the radio is receiving.
CTCSS/DCS: While receiving signal, the radio is allowed to transmit the CTCSS/DCS received is
different; and is not allowed to transmit if both frequecy and CTCSS/DCS are the same.
You can use programming software to select the level of the VOX sensitivity (1-9 levels).
You can set the high power or low power for each channel by programming software.
You can use programming software to adjust the squelch level (0-9 levels).
You can hear a beep sound when turn on the radio or press a key. You can use programming
software to open or close this function.
TOT is use the prevent any user a channel for a long time .it will damage the radio if transmit for
You can use the programming software to set the CTCSS/DCS for each channel.
There are 38 groups of CTCSS and 83 groups of DCS for you to select.
You can use the programming software to set the wide/narrow band for each channel.
In case of emergency, press emergency key the radio will sound alert tone and also send alert
This function can decrease power consumption no signal is received.and no operation performed.
You can use PC software to open or close this function.
To Next Page
Loading...
Need help?
General
