It is very usefully for hand free users to eliminate the End Roger Beep,
You can use programming software to open or close this function.
Low battery warning alerts you the battery should be recharged or replaced. While transmitting or
receiving, the LED will blink red if the battery is low. Please replace the battery if “du du” tone
1. Use cable to connect Master unit ,and turn on the slave unit .Press and hold programmable Side
Key 2 to turn ON master unit ,, LED flash Orange twice.
2. Press PTT of Master unit to transmit the data and Slave unit begin to receive data from Master
3. During cable cloneing Master unit blink red and Slave unit blink Green
4. When cloning completed , Slave unit restart automatically.
5. Switch to next slave unit and power on,press side key2 of master unit to clone.
6. Power of master unit to exit
During data transmission, if no data received 3 seconds Master unit flash Red (0.5s ON, 0.5s OFF)
1. Press PTT to send . 2.Release PTT to send.
4. OFF (DTMF Encode only).
OFF: Press PTT or release it will not send ANI code.
PRE-TX: Press PTT to send the ANI
POST-TX: Release PTT to send the ANI.
BOTH: Both press PTT and release to send ANI.
THE SIDE KEY CAN BE PROGRAMMED THE FUNCTIONS AS FOLLOW
To Next Page
Loading...
Need help?
General
