Motorola APX 8000 User Manual

• Press to return to the Home screen.
7.30.17.4
Editing the Soft ID
Prerequisites: Your radio must be preprogrammed to allow you to use this feature.
When and where to use: This feature allows you to change your username.
Procedure:
1 Perform one of the following actions:
• Press the preprogrammed Info button.
•
or to Info and press the Menu Select button directly below Info.
2 or to Soft ID and press the Menu Select button directly below Sel.
The display shows the current Soft ID.
3 Perform one of the following actions:
• Press the Menu Select button directly below Edit to edit the current Soft ID.
• Press the Menu Select button directly below Back to return to the previous screen.
A blinking cursor appears in the Edit Soft ID screen.
4 Use the keypad to edit the text.
5 Perform one of the following actions:
• Press the Menu Select button directly below Ok to save the new Soft ID and return to the
previous screen.
• Press the Menu Select button directly below Cncl to return to the previous screen.
7.30.18
Front Panel Programming
This feature only supports Model 3.5 and Model 2.5.
You are able to customize certain feature parameters in Front Panel Programming (FPP) to enhance
the use of your radio.
The radio can be programmed in two ways:
• Front Panel Programming (FPP) using the front panel controls of the radio.
• Customer Programming Software (CPS), with the radio connected to a PC computer.
There are two methods to program a channel within a zone. Either:
• Select the zone and channel through the radio interface, and then initiate the FPP feature. Or,
• Initiate the FPP feature, and then select the zone and channel.
NOTE: When any of the Rx parameters such as Rx frequency, Rx PL, Rx DPL, and Rx NAC
is changed, FPP automatically copies these Rx parameter values to the equivalent Direct
operation (also known as Talkaround operation) parameters. If you use FPP to change the Rx
frequency to be the same as the Tx frequency and subsequently use the CPS to read then
write to the radio, Direct/Talkaround mode will operate differently from when a receive channel
parameter value is changed through FPP. Refer to the CPS help files for a description of Direct/
Talkaround Mode operation, in respect to a CPS write to the radio.
MN001425A01-AW
Chapter 7 : Advanced Features
140

Motorola APX 8000 Specifications

General

Water Resistance	IP68
P25 Phase	P25 Phase 1 and Phase 2
GPS	Yes
Channels	3000 channels
Display	Full-color LCD
Encryption	AES, DES
Operating Temperature	-30°C to +60°C (-22°F to +140°F)
Bluetooth	Bluetooth 4.0