39
The LED lights solid
purple, and displays
charging status
when the radio is
turned off. The APX
VA will disconnect
itself from the radio.
A hand mic or Visor
Mic, is added or
removed after the radio
is turned on.
Note: Microphone accessory should be
installed by the installer.
If the user removed any cables, then the error
can be cleared by taking the following steps:
1. Turn off the radio.
2. Turn the radio on.
3. If there is at least one attached accessory,
the LED will switch to showing charging
status when the radio is turned off and
continue to do so after the radio is turned on.
If there is no attached accessory, this is
covered by the case in which no mic is
attached.
If the error persists, please contact the installer.
The LED lights solid
purple when the
radio is turned on,
and displays
charging status
when the radio is
turned off. The radio
will not detect the
APX VA.
When the radio is
turned on, there is no
unsupported IMPRES
accessory present,
and there is a
supported hand mic or
Visor Mic present, but
the LED lights solid
purple.
If at least one supported microphone accessory
is correctly connected, and no unsupported
accessory is connected, and then contact the
installer.
The LED does not
light. The radio will
not detect the VA. If
the VA is attached to
the radio, it will
disconnect itself
from the radio.
Note: In some
cases, the LED
might intermittently
flicker.
The VA has
experienced a failure.
To clear the error, take the following steps:
1. Turn off the radio.
2. Remove the radio.
3. Reinsert the radio.
4. Turn the radio on.
If the error persists, please contact the installer.
The LED lights solid
purple if starter
motor runs while
turning the radio on
or inserting it into the
APX VA.
False Error Indication. To clear the error, take the following steps:
1. Turn off the radio.
2. Remove the radio.
3. Reinsert the radio.
4. Turn the radio on.
If the error persists, please contact the installer.
Engage Button does
not lock.
The engage button and
associated APX VA
Connector has an
issue locking onto the
APX Radio.
Check that the battery is fully seated and the
radio is pushed fully into the charger.
The radio only slides
partially into the
charger.
Radio does not fully
seat into the APX VA
pocket.
Rotate the radio 180° and re-insert into the unit.
Condition Description Remedy
MN000350A01.book Page 39 Tuesday, March 29, 2016 2:14 PM
To Next Page
Loading...
