• or to scroll through the address list and
highlight the required address.
•
or to [Other Recpnt] and press the
Menu Select button below Edit. When a
blinking cursor appears in the Enter Address
screen, use the keypad to type the address
entry.
9
Press the Menu Select button directly below Send
or press the PTT button to send the message.
The display shows the Send Message screen and
Sending msg.
If the message is sent, you hear a tone and the
display shows Msg sent.
If the message is not sent, you hear a low tone,
the display shows Send failed and returns to the
main TMS screen.
Note:
You can append a priority status and/or a
request reply to your message. See Priority
Status and Request Reply of a New Text
Message on page 93 for more
information.
You can also select the Drft option to
save your message in the Drafts folder to
send it at a later time. See Accessing the
Drafts Folder on page 98 for more
information.
Sending a Quick Text Message
Quick Text messages are messages that are
predefined and usually consist of messages that are
used most frequently.
Each Quick Text message has a maximum length of
50 characters.
1 Perform one of the following actions:
• To access this feature via a preprogrammed
button, press the preprogrammed Quick Text
button and proceed to Step 4.
• To access this feature via the menu, proceed
to the next step.
2
or to TMS and press the Menu Select button
directly below TMS to access the TMS feature
screen.
3 Perform one of the following actions:
92
English
To Next Page
Loading...
Need help?
General
