24
General Radio Operation
Select a Channel
Consult an authorized service technician for the right choice between
the following methods.
Use the Preprogrammed Channel Selector
Use the Menu Entry CHAN
After the zone you want is
displayed, turn the
preprogrammed Channel
Selector switch to the
desired channel.
1 Press U to find CHAN.
2 Press D, E, or F
directly below CHAN.
The display shows the
current channel name (in
this case, DISP NW) blinking
and the zone (POL), not
blinking.
3 Press U to find the channel
name you want.
Note: If the channel you
selected is
unprogrammed,
repeat step 3.
CHAN
POL DISP NW
POL DISP SE
UNPROGRAMMED
94C05-F_.book Page 24 Wednesday, May 7, 2008 6:53 PM
To Next Page
Loading...
