Motorola ATS 2500p

NOTICE:
The following buttons combination are
supported.
• Radio Side Button 1 and Orange button.
• Radio Side Button 1 and accessory
Orange button.
• Accessory 1-dot Button and radio
Orange button.
• Accessory 1-dot Button and accessory
Orange button.
Sending an Emergency Alarm
This feature allows you to send a data transmission, which
identifies the radio sending the emergency, to the
dispatcher.
NOTICE:
The default timer of Emergency button press to
activate Emergency is milliseconds. This timer is
programmable from milliseconds by a qualified
technician.
Press the preprogrammed Emergency button.
One of the following scenarios occurs:
• The display shows Emergency and the current
zone or channel. You hear a short medium-
pitched tone and the LED blinks red momentarily.
• The radio sounds a short low-pitched tone to
indicate that the selected channel does not
support emergency and rejects to launch
emergency mode. The display shows No
emergency, if the selected channel does not
support emergency.
When you receive the dispatcher’s acknowledgment, the
display shows Ack received. Four tones sound, the alarm
ends, and the radio exits the Emergency Alarm mode.
If no acknowledgment is received, the display shows No
acknowledge. The alarm ends when the timer expires and
the radio exits the Emergency Alarm mode.
English
71