Getting started - Connecting Devices 17
ENGLISH
• Tap on VIEW to show the Camera view and other Camera controls.
(picture S17)
If you cannot find the camera ID on the list, or installation fails, please reset the
Camera with the following procedure:
1. Slide the ON/OFF switch to ON.
2. Press and hold the RESET button on the underside of the Camera for 5
seconds, until you hear a beep.
3. Release the RESET button and wait for the Camera to complete the
internal reset procedure.
4. After about 60 seconds you will hear two short beeps.
5. Wait for up to approximately five minutes. If the connection process takes
longer, tap on CANCEL and try again.
6. Ensure that you have a good working network connection and the green
LED is blinking.
To Next Page
Loading...
Need help?
General
