47
Advanced settings
Note
When you are storing a phone number in the Block list, you will need to store
the full number including the dialing code for the number to be blocked.
If you want to change/delete the block number, follow the first 4 steps above.
Then scroll to the slot where the number is stored and press the left O key.
Delete the number by pressing the right O key. Then either press the left O key
to save no number or enter the new number. Press the left O key to save.
12.2 Area code
The area code must be 3 digits long.
1. Press the left O key, scroll D to
Advanced set
.
2. Press the left O key, scroll D to
Area code
.
3. Press the left O key, enter the area code.
4. Press the left O key to confirm.
12.3 Flash time
Depending on your country and network operator, your phone has the flash
time set as long. It is unlikely that you need to change this setting unless
advised to do so.
1. Press the left O key, scroll D to
Advanced set
.
2. Press the left O key, scroll D to
Flash time
.
3. Press the left O key, press U or D to select
100ms, 250ms
or
600ms
.
4. Press the left O key to confirm.
12.4 Dial mode
Your phone is set to tone dialing. You should only need to change this if
connected to an older type of switchboard / PBX which requires pulse dialing.
1. Press the left O key, scroll D to
Advanced set
.
2. Press the left O key, scroll D to
Dial mode
.
3. Press the left O key. Then press U or D to select
Tone
or
Pulse
.
4. Press the left O key to confirm.
12.5 Switch Auto clock on / o
If you have subscribed to Caller ID service, the date and time will be set on all
your handsets whenever a call is received. This feature can be set to On or O.
1. Press the left O key, scroll D to
Advanced set
.
2. Press the left O key, scroll D to
Auto clock
.
3. Press the left O key, scroll D to
On
or
O
.
4. Press the left O key to confirm.
To Next Page
Loading...
Need help?
General
