35Base settings
4. Scroll
u
or
d
to
All Handsets
or
Select Handset
then press
Select
.
If you choose
Select Handset
, all available handsets are displayed.
• Scroll
u
or
d
to the handset you want then press
Select
.
• Scroll
u
or
d
to the number of rings that you want to set:
2
,
4
or
6 Rings
and press
Select
.
5. Press n to return to standby.
9.5 Recall mode
Recall is useful to access certain network services and PABX / switchboard services.
The default recall mode preset in the CD3 is suitable for your country network and
therefore you should not need to change it.
NOTE
The use of the CD3 cannot be guaranteed on all PABX.
1. Press
Menu
, scroll
d
to
Settings
and press
Select
.
2. Scroll
d
to
Set Base
and press
Select
.
3. Scroll
d
to
Recall Mode
and press
Select
.
4. Scroll
u
or
d
to
Recall 1
(100ms) or
Recall 2
(600ms) and press
Select
.
5. Press n to return to standby.
9.6 Change the System PIN
The System PIN is required when changing certain settings and for registration / de-
registration. The default setting is 0000. You can change this to your own preferred number
(up to 8 digits).
When you enter a PIN, the digits are shown as
****
.
1. Press
Menu
, scroll
d
to
Settings
and press
Select
.
2. Scroll
d
to
Set Base
and press
Select
.
3. Scroll
d
to
System PIN
and press
Select
.
4. Enter the old PIN (Default setting = 0000) and press
OK
.
5. Enter the new PIN and press
OK
.
6. Re-enter the new PIN and press
OK
.
7. Press n to return to standby.
NOTE
It is advisable to make a note of your new PIN code and keep it somewhere safe.
To Next Page
Loading...
Need help?
General
