Motorola CD4010 - Adjust the Speaker Volume; Delete All Messages; Outgoing Messages (Ogms); Record also

33
Using your Answering Machine
•
Repeat press M to repeat current message.
• Next press M to play next message.
• Previous press M to play previous message.
• Delete press M to delete the current message.
7. Press
e
to stop playback and return to standby.
9.3 Adjust the speaker volume
You can adjust the base loudspeaker volume from low to high. Press + to
increase the volume, or
- to decrease the volume.
9.4 Delete all messages
1. Press M, scroll
u
or
d
to Answ. Machine and press M.
2. Scroll
d
to Delete all and press M.
3. Display shows
Confirm? , press M.
9.5 Outgoing messages (OGMs)
This is the message your callers hear on the answer machine. There are two pre-
recorded outgoing messages, or you can record your own.
9.5.1 Record also
The pre-set Record also outgoing message, that allows your caller to leave a
message, is ‘Hello, your call cannot be taken at this moment, so please leave your
message after the tone’.
9.5.2 Answer only
The caller can listen to your announcement but cannot leave a message. The
pre-recorded message is ‘Hello, your call cannot be taken at this moment, and you
cannot leave a message, so please call later.’
9.5.3 Record, play or delete your own outgoing message
1. Press
M, scroll
d
to Answ. Machine and press M.
2. Scroll
d
to Announcment and press M.
3. Press
u
or
d
to select either Answer only or Record also and press M.
Scroll
u
or
d
to select either Play , Record or Use default and press M.
If you select
Play the current OGM will play back.
If you select
Record once you hear the beep speak your message into the handset,
to end recording press
M. The OGM will play back.
If you selected
Use default the display shows Confirm? , press M to confirm.