9
Getting started
2. Clip the battery cover back into place.
3. When charging the battery pack for the first time, place the handset on the
base to charge for at least 16 hours continuously.
4. When the handset is fully charged,
f will appear steadily on the display. Plug
the other end of the telephone line cord (make sure that one end is already
plugged into the base) into the telephone wall socket.
Connecting the handset and charger
(for multi-pack only)
If you have purchased a multiple pack, you will need to carry out this process for
all the handsets and chargers.
1. Plug the power adaptor connector into the socket marked
on the
underside of the charger and plug the other end into the mains power wall
socket.
2. Remove the battery cover from the back of the handset by placing your finger
in the groove at the bottom of the handset and lifting the cover up to release,
then insert the 300mAh Ni-MH battery pack supplied.
3. Clip the battery cover back into place.
4. When charging the battery pack for the first time, place the handset on the
charger to charge for at least 16 hours continuously.
5. When the handset is fully charged,
f will appear steadily on the display. The
display will show the time and the date on the screen, to indicate that it is
registered to the base.
BATTERY LOW WARNING
If
l flashes on the display and there is a warning beep every 2 minutes during a
call, recharge the handset before using it again. When charging,
f will scroll on
the display.
To Next Page
Loading...
