29
English
SCAN
SCAN
Your radio can monitor multiple channels in a
scan list. Your dealer can program up to 16
different channels into each scan list. When
your radio detects activity on a scan list
channel, it will automatically switch to that
channel.
Note: The same channels can be assigned to
different scan lists.
STARTING OR STOPPING SCAN G
The G symbol, and the number of the
channel you are transmitting on, will appear on
the display when you start a scan operation.
The green LED indicator blinks during a scan
operation and stops blinking when the radio
switches to a channel.
Note: If you enter Menu Mode while the radio
is scanning, scanning will stop. It will
resume when you exit Menu Mode.
You can start or stop a scan operation in one of
three ways:
Method 1
Press the preprogrammed Scan button (see
page 6) to start or stop scanning.
–or–
Method 2 (with the enhanced keypad
microphone)
–or–
Method 3
If programmed by your dealer, the radio will
start scanning when you select a channel that
has auto scan enabled.
1
Press the
Menu/Enter
button to
enter Menu
Mode.
2
y or z until
3
Press the
Menu/Enter
button to
select
4
y or z until
–or–
5
Press the
Menu/Enter
button to
confirm your
selection.
System Scan
System Scan
Sys Scan On?
Sys Scan Off?
To Next Page
Loading...
