RADIO OVERVIEW
8
English
OPERATION WITH MENU SETTINGS
Press Menu button to navigate through the Menu settings. Voice Assisted Operation feature* (* may not
be available on certain previous shipping radios). At any time in Menu mode, short press PTT or wait
3 seconds to exit the menu.
HOW TO… STEP 1 STEP 2
Change Channel Press Menu button to navigate to Channel. Press +/- button to change
channel.
Enter Monitor Mode Press Menu button to navigate to Monitor. Press +/- button to activate or
deactivate Monitor.
Enter Scan Mode Press Menu button to navigate to Scan. Press +/- button to activate or
deactivate Scan.
Send Call Tone
(enabled through CPS)
Press Menu button to navigate to Call Tone. Press +/- button to send Call
Tone.
Quick Tip: It is not necessary to wait for the voice prompt to be completed before continuing with next button press.
Note: For single channel models, Monitor, Scan Mode and Call Tone are supported. Single channel models
support Scan mode when the user enables “Dynamic Talkaround Scan” on a repeater channel via the
customer programming software.
To Next Page
Loading...
