Chapter 4
UHF3 PCB/SCHEMATICS/PARTS LISTS
1.0 Allocation of Schematics and Circuit Boards
1.1 UHF2 (465-495MHz)
The UHF circuits are contained on the printed circuit board (PCB) which also contains the Controller
circuits. This Chapter shows the schematics for the UHF circuits, the Controller circuits are
contained in Section 2 of this manual. The PCB component layouts and the Parts Lists in this
Chapter show both the Controller and UHF circuit components. The UHF schematics and the
related PCB and parts list are shown in the table below.
1.2 Six Layer Circuit Board
The main PCB is a 6-layer circuit board, the copper steps are in the layer sequence shown below.
Table 4-1 UHF3 Diagrams and Parts Lists
PCB :
8486634Z02_O Main Board Top Side
8486634Z02_O Main Board Bottom Side
Page 4-3
Page 4-4
SCHEMATICS
Radio Circuit Block Diagram
Receiver Front End
Receiver Back End
Synthesiser
VCO
Transmit and Power Control Cct
Page 4-5
Page 4-6
Page 4-7
Page 4-8
Page 4-9
Page 4-10
Parts List
8486634Z02_O Page 4-11
LAYER 1 (L1)
LAYER 2 (L2)
LAYER 3 (L3)
LAYER 4 (L4)
LAYER 5 (L5)
LAYER 6 (L6)
INNER LAYERS
SIDE 1
SIDE 2
To Next Page
Loading...
