Chapter 2
TROUBLESHOOTING TABLES
1.0 Troubleshooting Tables for Board and IC Signals (includes
Controller, DC Regulation and Audio)
This section contains detailed troubleshooting tables. These tables should be used as a guide in
determining the problem areas. They are not a substitute for knowledge of circuit operation and
astute troubleshooting techniques. It is advisable to refer to the related detailed circuit descriptions
in the theory of operation sections prior to troubleshooting a radio.
Most troubleshooting tables end up by pointing to an IC to replace. It is not always noted, but it is
good practice to verify supplies and grounds to the affected IC and to trace continuity to the
malfunctioning signal and related circuitry before replacing any IC. For instance, if a clock signal is
not available at a destination, continuity from the source IC should be checked before replacing the
source IC.
IC Designator Pin Pin Function DC Voltage Comments (Condition)
U310
5V Regulator
1 Vin 7.48
2 Ground GND
3 Control input 7.48
4 Bypass capacitor 1.26
5 Vout 4.96
U320
3.3V Regulator
1 Ground GND
2 Feedback 1.23
3 Tap (NU) 0
4 Vin 7.48
5Vout 3.23
6 Sense (NU) 0
7 Error (reset output) 3.20
8 Shutdown input 7.48
U330
3V Regulator
1 Vin 7.48
2 Ground GND
3 Control input 7.48
4 Bypass capacitor 1.26
5Vout 3.00
To Next Page
Loading...
