What to do if my Motorola CP185 Two-Way Radio is dead and the display doesn't turn on?
If your Motorola Two-Way Radio display doesn't turn on and the radio appears dead, the issue might be a dead battery. Try replacing it with a charged battery. If that doesn't work, the issue may be with the On/Off switch.
What to do if I get an ERROR message when cloning my Motorola CP185?
If you receive an 'ERROR' message on your Motorola Two-Way Radio during cloning, it means that cloning between the source and destination radios has failed. Check the connection between the radios and ensure you are following the correct cloning procedures.
What does COMM ERR mean on my Motorola CP185 Two-Way Radio during cloning?
A 'Communication Error' during cloning of your Motorola Two-Way Radio indicates a failure in communication between the source and destination radios. Check the connection between the radios. Ensure you are following the correct cloning procedures.
What to do if my Motorola CP185 shows a TIME OUT error during cloning?
A 'Time Out Error' on your Motorola Two-Way Radio during cloning indicates a lack of communication between the source and destination radios. To solve this, check the connection between the source and destination radios and ensure you are following the correct cloning procedures.
What does FATALERR mean on my Motorola CP185?
If your Motorola Two-Way Radio displays 'FATALERR', it means the codeplug is corrupted. You should reprogram the codeplug with the correct version and retest the radio.
What does PLLERROR mean on my Motorola CP185 Two-Way Radio?
The 'PLLERROR' message on your Motorola Two-Way Radio indicates a PLL Unlock Error, meaning the radio cannot receive or transmit on the programmed frequencies. To fix this, reprogram the codeplug with the correct version and retest the radio.
What does SLFTFAIL mean on my Motorola CP185 Two-Way Radio?
If your Motorola Two-Way Radio displays 'SLFTFAIL', it means the radio failed to initialize during start-up. Retest the radio by turning it off and then on again.
How to fix a Motorola CP185 with no display?
If your Motorola Two-Way Radio has no display, it could be due to the display module not being connected properly or the display module being damaged. Check the connection between the main board and the display module. If the connection is secure, replace the display module.
What does ERR-EEP mean on my Motorola CP185?
If your Motorola Two-Way Radio displays 'ERR-EEP', it indicates an EEPROM Error, meaning the codeplug is corrupted. Reprogram the codeplug with the correct version and retest the radio.
What does TYPE ERR mean on my Motorola CP185?
A 'TYPE ERR' message on your Motorola Two-Way Radio indicates a Mismatch Radio Type Error, meaning the source and destination radio models are different. Retest by connecting the same source and destination radio model.
General| Channels | 16 |
|---|---|
| Power Output | VHF: 5W, UHF: 4W |
| IP Rating | IP54 |
| Frequency Range | VHF: 136-174 MHz |
| Drop Test | MIL-STD-810F |
| Battery Life | Up to 11 hours (high capacity battery) |
| Weight | 335g (with standard battery) |
To Next Page
