Section 5: Configuring TCP/IP 22
⽧ Configuring TCP/IP in Windows 2000 (page 22)
⽧ Configuring TCP/IP in Windows XP (page 26)
This section contains two examples of configuring TCP/IP in a Windows environment. Most computers
already have the TCP/IP configuration enabled. Use the following procedures to verify that the configuration is
set up.
All client computers on your network must be configured for TCP/IP (the protocol that controls communication
among computers).
Configuring TCP/IP in Windows 2000
1. On the Windows desktop, click Start.
2. Select Settings and then Control Panel from the pop-up menus to display the Control Panel window:
Figure 13: Windows Control Panel
Note: Follow the instructions in your computer user manual for other Operating Systems.
Section 5: Configuring TCP/IP
To Next Page
Loading...
