11Using the phone
3.3 Redial
The last entry dialled is stored in the phone; this can be up to 32 digits long.
1. Pick up the handset and press .
Or:
2. Press and then .
3. Once the call is answered lift the handset to talk.
3.4 Redial list
At least the last 8 entries dialled are stored in the phone, the numbers can be up to 16
digits long.
To dial a number from the Redial list
1. Press .
2. Keep pressing to scroll to the entry you want.
3. Press and hold button for 3 seconds to scroll through the numbers quickly.
4. Lift the handset or press to dial the displayed entry.
3.5 Dial mode
Your phone is set to tone dialling. You should only need to change this if connected to an
older type of switchboard / PABX which requires pulse dialling.
1. Press and hold for 3 seconds to change the setting.
3.6 Recall mode
Recall is useful to access certain network services and PABX /switchboard services. Your
CT320 has 2 recall buttons is the short flash time and is for long flash time.
3.7 Turn anti-dialling from an extension on / o
On some PABX’s you can set the CT320 to cause interference on the line so another
extention cannot be used.
1. Press and hold for 3 seconds to change the setting.
To Next Page
Loading...
Need help?
General
