42 Wall mounting
12. Wall mounting
IMPORTANT
Before you wall-mount your D1000, check that you are not
drilling into any hidden wiring or pipes.
Before you drill, make sure the power and telephone line
cables will reach the sockets.
1.
Use the following templates to mark the drilling locations.
• To wall-mount the base, drill two holes in the wall 4.5cm
apart horizontally using an 8mm drill bit.
• To wall-mount the charger, drill two holes in the wall
3.2cm apart horizontally using an 8mm drill bit.
To Next Page
Loading...
Need help?
General
