SCAN
Scan
16
English
SCAN CHANNEL DISCOVERY
ALERT
Sometimes you need to know which channel the
radio has switched to during a scan operation.
The Scan Channel Discovery Alert gives you this
information.
After you have stopped a scan operation, this
feature gives you audio feedback when you
select the last channel that was switched to by
the scan operation. To do this:
SCAN LIST MEMBER PRIORITY
A channel in your scan list may be prioritized
(check with your dealer for details). In such a
case, the radio will check that prioritized channel
more frequently than the other non-prioritized
channels.
Assuming a scan list with 6 channels, if all your
channels are non-prioritized, the normal scan
operation would check for activity in the following
sequence:
If Channel 2 is prioritized, the scan operation
would change to
NOTE: Even though your radio has switched to a
non-priority channel, your radio will still check for
activity on the priority channel. If some activity is
detected there, the radio will switch to that prior-
ity channel.
1. Stop the scan operation.
2. Turn the Channel Selector to change the
channels.
3. When you reach the last channel the scan
operation switched to, the radio sounds an
alert tone.
C
h
.
1
C
h
.
3
C
h
.
4
C
h
.
5
C
h
.
2
C
h
.
6
C
h
.
2
C
h
.
4
C
h
.
2
C
h
.
2
C
h
.
2
C
h
.
5
C
h
.
1
C
h
.
6
C
h
.
3
C
h
.
2
To Next Page
Loading...
