Motorola GP338

Phone
34
English
PHONE
• manual (for radios with keypad only)
• automatic delay
• automatic immediate.
Check with your dealer for more details.
Sending the Phone Number
After the access code is sent, you should wait
for a dialing tone before sending your phone
number.
You can send
• a phone number that is stored in the
radio, or
• a new number (for radios with keypad
only).
Additionally, depending on how your radio is
programmed, if you use the keypad to send a
number, the radio can send the numbers in one
of the following ways:
• live dial
• buffered dial.
Check with your dealer for details.
Sending a Stored Phone Number
You can access the stored phone numbers by
• recalling the last number dialed,
• using the phone list, or
Method
Used
Steps to Take
Manual
*
Dial the access code from the
keypad.
Automatic
Delay
Press and release the PTT; the
radio automatically sends the
preprogrammed access code.
Automatic
Immediate
You do not have to do anything;
the radio immediately sends the
access code when it enters phone
mode.
*
for radios with keypad only
#WarisPreUser.book Page 34 27, May 1998, 9:44 AM