Doc Title : Product Data - User Manual Revision : R.00
Model : Motorola L702 series Page(s) : 25 of 36
This document contains confidential and proprietary information of VTech Telecommunications Ltd
4.15 Setting the dial mode
The default dialing mode is suitable for your country and network operator. It is unlikely that you should need to
change this setting unless advised to do so.
1. Press MENU/SELECT and then UP or DOWN to select
.
2. Press MENU/SELECT to select DAIL MODE.
3. Press MENU/SELECT and then UP or DOWN to select TONE or PULSE.
4. Press MENU/SELECT to save.
NOTE
If the pulse mode is selected, press TONE/* to switch from pulse to tone dialing temporarily when dialing out. After
the call is ended, the dial mode will change back to pulse.
4.16 Setting the flash time
The default flash time is 600MS. It is unlikely that you should need to change this setting unless advised to do so.
1. Press MENU/SELECT and then UP or DOWN to select SETUP BS.
2. Press MENU/SELECT and then UP or DOWN to select
.
3. Press MENU/SELECT and then UP or DOWN to the flash time you want. ( 8 options are available :
110, 250, 300, 400, 600 and 700MS)
4. Press MENU / SELECT to save.
4.17 Setting the area code
1. Press MENU/SELECT and then UP or DOWN to select
.
2. Press MENU/SELECT and then UP or DOWN to select
.
3. Press MENU/SELECT and then enter the area code.
4. Press MENU/SLECT to save.
Up to 5 cordless handsets can be registered to a corded base. The original cordless handset is pre-registered to
use. Additional handsets must be registered to the corded base before you can use them.
To register an additional cordless handset,
1. Press MENU/SELECT and then UP or DOWN to select
.
2. Press MENU/SELECT and then UP or DOWN to select
.
3. Press MENU/SELECT and then UP or DOWN to select
or
.
4. Select YES then press MENU/SELECT to enter the registration procedure as follows:
1. Press and hold INT / FIND for around 4 seconds on the corded base.
2. Place the unregistered cordless handset on the charger.
3. A confirmation tone is generated if registration is successful. HANDSETX is displayed where X denotes
the number of handsets, and then the phone returns to idle.
To register an originally unregistered handset, follow steps 1 through 3 above.
4.19 Resetting all settings
1. Press MENU/SELECT and then UP or DOWN to select RESET SETTINGS.
2. Press MENU/SELECT and then UP or DOWN to select ALL SETTINGS.
3. Press MENU/SELECT to select
. All personalized settings will be reset to default.
NOTE
All of your phonebook entries, calls list, and redial list, will remained unchanged.
4.20 Using your answering machine
1. Press MUTE/CLEAR/X on the handset from idle mode. New messages will be played followed by any older
messages
2. During the message playback, press the keys below on the handset to perform the following functions:
KEY1 Press to repeat the current message from the beginning. Press twice to playback the previous message.
KEY2 Press to stop the current message playback.
KEY3 Skip to play the next message