10 GETTING STARTED
3. Insert the supplied battery pack, and fit the battery
pack into the compartment.
4. Reattach the battery compartment cover, and reinstall
the belt clip (refer to section 2.3).
5. Insert the power adapter with bigger pin plug into the
side of the parent unit.
6. Connect the other end of the power adapter to the
power outlet.
7. The Charging Indicator comes on.
NOTE
Only use the provided power adapter.
2.3 Belt clip on parent unit
1. Attach the belt clip to the lock slots on the back sides.
2. The accessory comes with the unit at belt clip mode.
3. You can convert into stand mode by lifting up the belt
clip and rotating by half turn.
To Next Page
Loading...
