Motorola MBP26 - Unit Registration (Pairing)

Getting Started 11
ENGLISH
2.4 Registration (Pairing)
The Baby monitor camera is pre-registered to your Parent Unit. You do
not need to register it again unless the Baby Unit loses its link with the
Parent Unit.
To re-register your Baby Unit, or register a new Baby Unit, follow the
procedure below:
1. Press the button of the parent unit and then press the
- DOWN
button to select the ADD CAMERA icon , and press the
button to confirm.
2.
1 / 2 / 3 / 4 will pop up, press the + UP button or - DOWN button to
select the desired Camera identification number and press the
button to start searching for a camera unit. The Green Audio Level
LED turns on while searching.
3. Press and hold the PAIR button under the bottom left edge of the
camera unit until the parent unit finds the camera, beeps and the
video from the camera appears.
NOTE
If a particular Baby Unit was registered previously, registering this current
Baby Unit again will overwrite the old registration.
If no camera unit is found within about 30 seconds, the search will end
and the parent unit will return to its previous mode.