Parent Unit Menu Options 15
ENGLISH
NOTE
You cannot delete the camera if it is the only camera paired in the system.
4.5.4 Scan the cameras
1. Press the button and the first menu option will appear.
2. Press the
- DOWN button to select the VIEW CAMERA icon
and press the button to confirm. Choose the symbol for scan
selection.
3. The screen will then display images from each registered cameras in
a loop, changing about every 10 seconds.
TIP
Quick Method to View Cameras instead of using the menu.
Directly press repeatedly to select
Camera 1 - 4
or .
NOTE
If the parent unit is in scan mode and one of the registered cameras is
turned off or out of range, the scan will stop at the missing camera
(e.g. camera) and display the
3 ?
icon while emitting a warning beep
every 8 seconds.
WARNING
Check the camera and correct the fault immediately if you are using that
camera to monitor your baby.
If you want to continue in camera scan mode without that camera, delete
the camera (see 4.5.3 Delete a camera) and start the scan again.
To Next Page
Loading...
