Motorola MBP30 - Registration

10 Getting started
2.4 Registration
The baby monitor is already pre-registered upon your purchase. You do
not need to register it again unless the baby unit loses its link with the
parent unit.
Up to 4 baby units can be registered to one parent unit. If you have
more than one baby unit, please check that you have selected the
correct channel at the Parent unit for that baby unit before you attempt
to register it again.
To re-register your baby unit, or register a new baby unit, follow the
procedure below:
1. Switch off the baby unit and remove the small power plug from the
baby unit.
2. On the Parent unit, press to enter menu mode.
3. Press
( or ) until is selected on the LCD screen.
4. Press
+ or - to select the camera channel ( 1 / 2 / 3 /
4 ) that you want the baby unit to pair with.
5. Press to start registration. is displayed during the
pairing process.
6. Switch on the baby unit.
Wait 16 seconds for the parent unit to locate the baby unit and pair it to
the selected channel. A will be displayed on the LCD screen if the
registration is successful.
If no baby unit is found, a will be displayed on the LCD screen.
Switch the baby unit off and on and repeat the registration procedure.